WLAR-L11@SCI - reused junk

シリアル接続

ピンヘッダ追加

SH3のSCIはJ1までパターンがつながっているので利用する。

J1	1pin	TXD	SH3-TXD0(164pin)
	2pin	RXD	SH3-RXD0(171pin)
	3pin	+3.3V
	4pin	GND

---

レベルコンバータの用意

BLR-TX4シリアル接続で使用したものと同じ

---

WLAR-L11起動ログ

ac000000 -- ac3fec3c : start 4byte mem check
Now filling...ac000000 -- ac3fec3f (adrs)
   ac000000
   ac100000
   ac200000
   ac300000
checking..
   ac000000
   ac100000
   ac200000
   ac300000
mem check complete

ac000000 -- ac3fec3c : FILL 0 data
-------------
debug_ident=0 rst_type=0 expevt=0 intevt=0 intevt2=0
 spc=0 ssr=0 reset_status=0

144458
P_CLK= 20 MHz  DBserial=57600  serial=115200   WLA_CLK_MODEHI= 1
** Free Program Area=206238
RAM_DEBUG_POINTER=c3fec00
 -- WLA_FLASH_BASE --
 firmsize=784996
 chksum=bef5c2c0
 fwcode=6
 author=HIRAI HABA OHARA TAMURA YAMAZAKI SUGAI
 date=Fri Oct 05 17:00:05 2001
 sig=[[WLAR-L11]]
 ver=220
 fwcode=6
 WLA_TYPE=4
 WLA_AREA_=0
HW model=00000036
RunTime CPU CHECK (CPU=SH7709)
all_initialize end
------ Application_Initialize (freemem=3488572)------
144458: *****  System_startup_task  *****
Init_SCI_Driver(): Create Driver
sci end
Init_SCI_Driver end
FUJITSU MBM29LV800T
FUJITSU MBM29LV800T
HW model=00000036
144458: Network Initialize start
144458: WLA setup data loading..
0000: 00 40 26 ** ** ** 00 00-00 00 00 00 00 00 00 00    .@&.............

AX88195 MAC 00:40:26:**:**:**
WEB data size=5664
WEB data size=6622
144458: mode is WLA_MODE_BRIDGE
** NetDriver [WLARL11] Ver.1.00 (Oct 05 2001-16:56:26)
-> WLARL11_Init
** NetDriver [AX88195] Ver.1.00 (Oct 05 2001-16:56:23)
-> AX88195_Open_Device in
== start AX88195 InternalRAM check ==
<- AX88195_Open_Device end
** ram_memcpy param err s=c15ac78 d=c15ac78 6
MAC ADR= 00 40 26 ** ** **
<- AX88195_Init
** NetDriver [LUCENT] Ver.1.00 (Oct 05 2001-16:56:21)
TPL code=1 size=3
TPL code=17 size=4
TPL code=1d size=5

x
 1o[W
        version=5 0
        MELCO WLI-PCM-L11 Version 01.01                                         
----  wvlan2_private  ----
PortType                        =1
Channel                 =0
TxRateControl           =3
APDensity                       =1
RTSThreshold            =2347
PMEnabled                       =0
MulticastReceive        =1
MaxSleepDuration        =100
MACAddress              =00:00:00:00:00:00
NetworkName             =AirStation
StationName             =AIRCONNECT
EnableEncryption        =0
WEPOption                       =0
Key1                            =
Key2                            =
Key3                            =
Key4                            =
TransmitKeyID           =1
----  IFB  ----
IFB_Version             =5
IFB_IOBase              =ba000300
IFB_IO_Range            =40
IFB_Magic                       =7d37
IFB_HCF_VersionMajor =2
IFB_HCFVersionMinor  =22
IFB_TickIni             =262144
IFB_CfgTblSize  =352
----  driver Info  ----
len                     =13
typ                     =2085
driver_name     =WVLAN49
driver_version  =400
HCF_version     =222
IO_address      =300
IO_range                =128
IRQ_number      =49
card_stat               =0
frame_type      =1
----  driver Info  ----
len             =5
typ             =2086
comp_id =49
variant =1
version_major   =4
version_minor   =0
WaveLAN AP Firmware download:Done.
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
WVLAN49: WaveLAN/IEEE,io_addr 0xba000300,irq_vect 49,
   mac_address 00:00:00:00:00:00
<- LUCENT_Init
<- WLARL11_Init
** Rip2 Bootup ******************
Call IpConfig Func
*** IPCONFIG_OPERATE(3),Interface(Local),IP(0),Mask(0)
GetMAC iface=0
NERR_FATAL/rip2.c/NU_Rip_Initialize 6
IP is 192.168.1.3
-- RATE=2
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
-- ESSID=8291BADEVELOP
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
-- CHANNEL=11
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
-- WEP Disable
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
** LUCENT WEP Option Disable
----  IFB  ----
IFB_Version             =5
IFB_IOBase              =ba000300
IFB_IO_Range            =40
IFB_Magic                       =7d37
IFB_HCF_VersionMajor =2
IFB_HCFVersionMinor  =22
IFB_TickIni             =262144
IFB_CfgTblSize  =352
        Port Type fail.
        RTS Threshold fail.
        Tx Rate Control fail.
        Power Management fail.
        CFG_CNF_MCAST_RX fail.
        CFG_CNF_MAX_SLEEP_DURATION fail.
-- MAC Filter Disable
**** SetPacketFilter
************* SetRIP
Call IpConfig Func
*** IPCONFIG_OPERATE(3),Interface(Local),IP(0),Mask(0)
GetMAC iface=0
** Rip2 Interface(WLAR-L11) seting ! sendmode = 0 recvmode = 3
NERR_FATAL/rip2.c/NU_Rip2_Change_Command 1
GetMAC iface=3

---