Linux version 2.4.28 (root@debian) (gcc version 3.3.6) #181 Sat Feb 24 18:41:28 JST 2007
BIOS-provided physical RAM map:
BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
BIOS-e801: 0000000000100000 - 0000000002000000 (usable)
32MB LOWMEM available.
On node 0 totalpages: 8192
zone(0): 4096 pages.
zone(1): 4096 pages.
zone(2): 0 pages.
DMI not present.
Kernel command line: rw console=ttyS0,38400 a亀牛A易亀椅≫
Initializing CPU#0
Calibrating delay loop... 44.33 BogoMIPS
Memory: 27396k/32768k available (1099k kernel code, 4984k reserved, 713k data, 56k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
CPU: After generic, caps: 00000000 00000000 00000000 00000000
CPU: Common caps: 00000000 00000000 00000000 00000000
CPU: Cyrix Cx486SLC
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
POSIX conformance testing by UNIFIX
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Cannot allocate resource region 0 of device 00:01.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
NTFS driver v1.1.22 [Flags: R/O]
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
r6040: RDC R6040 net driver, version 0.12 (24March2006)
r6040: RDC R6040 net driver, version 0.12 (24March2006)
PCI: Setting latency timer of device 00:08.0 to 64
r6040: RDC R6040 net driver, version 0.12 (24March2006)
PCI: Setting latency timer of device 00:09.0 to 64
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
IT821x: unknown IDE controller at PCI slot 00:04.0, VID=1283, DID=8211
IT821x: chipset revision 17
IT821x: not 100% native mode: will probe irqs later
it8212: forcing bypass mode.
it821x: controller in pass through mode.
ide0: BM-DMA at 0xa410-0xa417, BIOS settings: hda:pio, hdb:pio
hda: SAMSUNG MP0402H, ATA DISK drive
blk: queue c02f6720, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x9410-0x9417,0x9812 on irq 9
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 78242976 sectors (40060 MB) w/8192KiB Cache, CHS=4870/255/63, UDMA(100)
Partition check:
hda:hda1
SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
physmap flash device: 400000 at ffc00000
enter cfi_probe_chip
send query command 98 55
Amd/Fujitsu Extended Query Table v1.1 at 0x0040
Physically mapped flash: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling fast programming due to code brokenness.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
ehci_hcd 00:0a.1: PCI device 17f3:6061
ehci_hcd 00:0a.1: irq 14, pci mem c2c01000
usb.c: new USB bus registered, assigned bus number 1
ehci_hcd 00:0a.1: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4
hub.c: USB hub found
hub.c: 2 ports detected
kusbd: /sbin/hotplug add 1
host/usb-ohci.c: USB OHCI at membase 0xc2c03000, IRQ 15
host/usb-ohci.c: usb-00:0a.0, PCI device 17f3:6060
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
kusbd: /sbin/hotplug add 1
usb.c: registered new driver usbscanner
scanner.c: 0.4.16:USB Scanner Driver
usb.c: registered new driver usblp
printer.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
NET4: AppleTalk 0.18a for Linux NET4.0
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 2559k freed
EXT2-fs warning: checktime reached, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
Freeing unused kernel memory: 56k freed
Journalled Block Device driver loaded
kjournald starting. Commit interval 5 seconds
EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
PCI: Setting latency timer of device 00:01.0 to 64
device eth1 entered promiscuous mode
device wl0 entered promiscuous mode
br0: port 1(eth1) entering learning state
br0: port 1(eth1) entering forwarding state
br0: topology change detected, propagating
Adding Swap: 131064k swap-space (priority -1)
最終更新：2007年03月07日 01:58
